Driverless Trucks May Use Cab-Mounted Beacons Instead of Warning Triangles for Five Years: What FMCSA’s Aurora Exemption Changes, and What It Does Not

Key points

  • On October 9, 2026 FMCSA published a five-year exemption, effective October 7, 2026 through October 7, 2031, that lets Aurora Operations and any other motor carrier operating Level 4 automated driving system trucks use cab-mounted amber warning beacons instead of placing warning triangles when a truck stops on the road or shoulder (91 FR 64736, Docket FMCSA-2026-0958).
  • The exemption covers three provisions: 49 CFR 392.22(b) (placing warning devices within 10 minutes), 393.25(e) (lamps must burn steadily) and 393.95(f) (the required warning devices). It applies only to trucks with no human driver on board to place the devices.
  • Nothing changes for a truck with a driver: hazard flashers go on at once, the triangles go out as soon as possible and always within 10 minutes, and the kit must hold three reflective triangles or at least six fusees (liquid-burning flares were removed from the rule on March 23, 2026).

What FMCSA granted

Aurora first asked for this relief in 2023. FMCSA denied that request on December 27, 2024, because it sought relief for “a class of unspecified carriers using unspecified equipment on unspecified vehicles” and lacked notice, reporting and equipment detail. Aurora then operated under temporary waivers, the first from October 10, 2025 through January 9, 2026 on 34 trucks, the latest running July 10 through October 9, 2026, while its new application (91 FR 20252, April 15, 2026) drew 402 comments. In the October 9 notice FMCSA finds that, with the conditions below, the beacons are likely to achieve a level of safety equivalent to, or greater than, the level achieved without the exemption, and grants it for the full five years allowed by law. The exemption can be revoked if a carrier fails to comply with its terms or if it is found to lower safety.

Who can use it, and how

Any motor carrier operating commercial motor vehicles equipped with a Level 4 automated driving system (as defined by SAE J3016) may use the exemption, but a carrier other than Aurora must first notify FMCSA in writing by email to [email protected] with its legal name, USDOT number, principal place of business and a point of contact, state that its trucks carry conforming cab-mounted beacons and that it can comply with every term, and include a certification under penalty of perjury (28 U.S.C. 1746). Operations are limited to roads inside the validated operational design domain for the specific truck. The exemption may not be used where a human driver would need an H, X, P or S endorsement, for passenger carriage, for hazardous materials as defined in 49 CFR 383.5, or for longer combination vehicles other than doubles with two 28-foot trailers.

The beacon conditions

  • Forward- and rearward-facing flashing amber lights: at least one rearward-facing light on each side of the cab and at least one forward-facing light on the front, on stable mountings, at least 100 inches above the ground (at or above the upper edge of the sideview mirrors and below the top of the cab), with the total vehicle width including lights no more than 122 inches.
  • Class 1 photometric performance under SAE J595, a flash rate different from the standard hazard flashers, and redundant power sources so that no single power failure disables the beacons.
  • Activation as soon as possible, and in any event within five minutes, whenever the truck is stopped on the traveled portion or the shoulder of a highway for any cause other than necessary traffic stops; the beacons flash for the entire stop and the hazard flashers also stay on.
  • Crash notice to FMCSA by email within five calendar days of any crash in which the beacons were, or should have been, activated, using the crash definition in NHTSA’s Standing General Order on crash reporting; a safety notice within five days if the carrier concludes the beacons no longer maintain equivalent safety; an annual report by November 1 each year covering trucks, miles, malfunctions, mounting locations and beacon variations; meetings with FMCSA on request; and compliance with every other Federal Motor Carrier Safety Regulation.

What does not change for every other truck

The exemption exists because a Level 4 truck has nobody on board to walk the triangles out. For a truck with a driver, 49 CFR 392.22 applies exactly as before: when the truck stops on the traveled portion or shoulder of a highway for any cause other than necessary traffic stops, the hazard flashers go on immediately and the warning devices go out as soon as possible, always within 10 minutes, one within 10 feet of the truck on the traffic side, one about 100 feet behind and one about 100 feet ahead on a two-lane road, and about 10, 100 and 200 feet to the rear toward approaching traffic on a divided or one-way highway, and farther back, 100 to 500 feet, where a hill, curve or obstruction hides the truck. Under 49 CFR 393.95(f), as amended effective March 23, 2026, the kit must hold three bidirectional emergency reflective triangles that meet FMVSS No. 125, or at least six fusees where flame-producing devices are allowed; liquid-burning flares are no longer listed. Fusees may never be carried on a vehicle transporting Division 1.1, 1.2 or 1.3 explosives, on a cargo tank used for flammable gas or flammable liquid, loaded or empty, or on a vehicle fueled by compressed gas (393.95(g)).

What to do this week

  1. Check the warning-device kit in every truck against the current rule: three FMVSS No. 125 triangles, or at least six fusees where permitted. Replace any kit that relies on liquid-burning flares.
  2. Brief drivers that a stopped automated truck showing amber cab beacons and hazard flashers is operating lawfully under this exemption, and that their own 10-minute duty is unchanged.
  3. If your company operates or plans to operate Level 4 trucks, file the notification with FMCSA before using beacons in place of triangles, and calendar the November 1 annual report.

Our Pre-Trip and Post-Trip Inspections and DVIR Driver Training covers the warning-device kit and its placement at the roadside.

Sources: FMCSA, Parts and Accessories Necessary for Safe Operation; Application for Exemption From Aurora Operations, Inc., 91 FR 64736 (October 9, 2026); 91 FR 20252 (April 15, 2026); FMCSA waiver terms and conditions, July 9, 2026; 49 CFR 392.22 and 49 CFR 393.95 on eCFR; 91 FR 7867 (February 19, 2026).

Scroll to Top